well, well, well....looks like the DIY'er
has had a couple of wins....
like a dog with a bone.....
I brought out the big guns...steel wool, stainless steel mesh cleaner, glass scraper, wire brush....and mineral turps...
I figured if the worst case applied, and I would have to replace that area of the dining room flooring...than I could do no more harm...
so I threw away the sandpaper, and brought the big guns in...
scraped away with a combination of the above...the stainless steel mesh was the best....then I poured a liberal amount of the turps onto the stained area....
after 10 minutes or so, I watched the floor peeling and breaking up like a skin.... so far there is a third to a half of the stain gone...
the elbow grease theory works...
I will go back to attack the remainder tomorrow....I believe I am going to correct my mistake
next, I sanded down the satin finish, in the kitchen area, and applied the matt finish.....I must say it looks very good...you would never know it has been fixed....
now I am confident I will be able to finish all the little areas, now that I know the Wattyl Floor product, in Matt finish is the right one to use...and melts in perfectly with the existing floor...
thanks for all your help
cheers
- Forums
- Lifestyle & Travel
- real tradesmen versus newbie handyman
real tradesmen versus newbie handyman, page-28
-
- There are more pages in this discussion • 35 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Featured News
The Watchlist
1CG
ONE CLICK GROUP LIMITED
Mark Waller, MD
Mark Waller
MD
Previous Video
Next Video
SPONSORED BY The Market Online