BeeJaye,
This is why cross-sections are useful.
Just for example to show a point;
Figure 4 in the Oct 19th announcement shows about a 45 degree NW plunge on the cross-section (for MAD060 line - no section shown for MAD126).
A 5.25m intersection on a vertical drill hole on a 45 degree plunging orebody gives a true thickness of 3.6m.
Therefore in this example 5.25m is a 46%
overestimation of thickness compared to the true thickness. It is not a directors special, but it is also not close to true width.
So, in this example, I would use a x0.68 multiplier (when looking at total Ni% calculations).
Example only to show a point, not directly about MAD126.
- Forums
- ASX - By Stock
- SGQ
- Ann: Best Ever Intercept At Investigators
Ann: Best Ever Intercept At Investigators, page-53
-
- There are more pages in this discussion • 72 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Add SGQ (ASX) to my watchlist
|
|||||
Last
3.2¢ |
Change
-0.001(1.56%) |
Mkt cap ! $34.83M |
Open | High | Low | Value | Volume |
3.2¢ | 3.3¢ | 3.2¢ | $96.25K | 3.009M |
Buyers (Bids)
No. | Vol. | Price($) |
---|---|---|
8 | 4256291 | 3.1¢ |
Sellers (Offers)
Price($) | Vol. | No. |
---|---|---|
3.2¢ | 123949 | 3 |
View Market Depth
No. | Vol. | Price($) |
---|---|---|
8 | 4256291 | 0.031 |
15 | 6681873 | 0.030 |
4 | 9150000 | 0.029 |
11 | 10439959 | 0.028 |
4 | 7537000 | 0.027 |
Price($) | Vol. | No. |
---|---|---|
0.032 | 123949 | 3 |
0.033 | 769966 | 5 |
0.034 | 376000 | 3 |
0.035 | 416105 | 3 |
0.036 | 667666 | 8 |
Last trade - 12.39pm 29/08/2024 (20 minute delay) ? |
Featured News
SGQ (ASX) Chart |