Australia's largest stock trading and investment forum Australia's #1 stock forum

Labor Rates!, page-164

First 164 Last

Share
Profile

Follow
The-Head

18,195 Posts.

27/07/20

20:11

Post #: 46104873
Share

Originally posted by Dave R: ↑

Copper pipe is best for hot water especially very hot water.
The 12mm stuff is fairly cheap and easy to bend smoothly to fit.
No need for solder any more as the elbows and T sections are brass with screw connectors which compress a nylon bush. Used to be copper bushes but nylon is better. Plastic is OK for cold water.
Also you can use the flexible hose if you want to but I find working with copper easy enough.
Waste water pipes are all plastic and very easy to cut and glue the fittings in place.
There is no special skill required any more for basic plumbing work.
Same applies to basic electrical work, everything is either colour coded or marked in some way.
Just take it slowly and carefully and you can't go wrong doing it yourself. And if you are uncertain of something just look up how to do it on the internet and follow the step by step instructions you will find there.

Expand

Jeez Dave they banned those fittings 30 years ago in Vic
A bit of movement and they leak
and if you extended the 15 mm more than 3 metres on the cold that’s not up to standard
1 Upvote

Reply

Top Stories

Tuesday's HotCopper trends: Sayona intercepts, Bowen Coking crisis | July 15

AII

Inside the depths of Panasqueira: A legacy carved in rock

Listen: HotCopper Wire Podcast 017 – RBA holds the toppings

ASX Market Close: Tariff fatigue truly evident; RBA eftpos proposal sinks Tyro

WIN

'Incorrect datasets': Old irony sets WIN Metals up for golden opportunity at Emjay

First 164 Last

SPONSORED BY