Pay Dirt, page-40

I've had a question regarding NDIBK01 within FFE for a while. On the portal they breakdown the lithology names for each segment of hole 01 (image below). Within this they categories a zone from 140m to 170m as porphyry with feldspar, quartz, mica. We can then compare this to the XRF minerals graphs indicated for Hole 1 (image below) showing a low grade Cu spike at 120-150m. So the question is, comparing cross section of the MT data cube C6, did the hole brush past the out edge of something or did i read into the porphyry label to much?









Cu in Hole 01 (within FFE area)

Iron Oxide total in hole 01 (within FFE area)