any metallurgists out there?, page-12

  1. sypaladin
    11,316 Posts.
    clock Created with Sketch.
    01/12/09
    00:07
    Post #: 5984271
    Teflon/nylon washers would be fine. You also would need to have Teflon/nylon cylinder in hole to insulate the thread, or use plenty of Duralac.

    You would have insulate the whole bolt so it touches nothing else.

    cheers,

    sypaladin
    Likes Created with Sketch.  Upvote
    Stroke 3 Created with Sketch. Comments Created with Sketch. Reply

  2. Top Stories

 

Featured News

NEWS Buying smarter as baby boomers get boost
right-arrow Created with Sketch.
RNU Renascor wins a funding boost given it wants to produce a critical mineral – but $5M award pales in comparison to some
right-arrow Created with Sketch.
TX3 Canadian fieldwork yields multiple pegmatites for Trinex
right-arrow Created with Sketch.
IMM Immutep reports strong response rate from immunotherapies treating carcinomas
right-arrow Created with Sketch.
NEWS ASX hits all time high out the gate on Friday trades following bullish US inflation data
right-arrow Created with Sketch.
NEWS What matters for FY25: Investment; interest rates; inflation & elections
right-arrow Created with Sketch.
arrow-down-2 Created with Sketch. arrow-down-2 Created with Sketch.