But if the wire to the solenoid isn't getting a signal to start with, that wouldn't be just a starter leaking to earth?
After looking at these wire diagrams, the wiring to the time delay module might be the best place to start. Obviously If I can by pass the starter from the ignition switch but then it dies when in motion. There is obviously no "good to go" signal along those wires.
- Forums
- DJPIN
- Fri 5/1/24 … missing two Johns Day
Fri 5/1/24 … missing two Johns Day, page-52
-
- There are more pages in this discussion • 1 more message in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Featured News
The Watchlist
AHK
ARK MINES LIMITED
Ben Emery, Executive Director
Ben Emery
Executive Director
SPONSORED BY The Market Online