damn, i bought too few pre the halt., page-9

Hi Winecollector,

I just drew it up on a piece of paper using a protractor just then.

36m is the depth down the hold which is dipping at 70 degrees. The ore body is vertical so the true thickness of the ore body is not 36 m but about 9 m.

my rough calculation was 4 its about 9-10

If the hole was horizontal then the true thickness is 36 m.

All drill data depths are doe the hole widths. They must be translated into true thickness and it depends on the dip of the ore body and the dip of the drill hole.

A horizontal ore body with vertical bolse such as IBG zinc deposit in greenland is allways true thickness

Have I explained it OK