New refractory lining in the cement industry for example is dried for 48h and then without any feed heatet up within 72h to 1500°C; after that feeding of raw meal is started.
To heat kilns of a size of the LAMP and then cool it down again, doesn't make any sense for two reasons:
1) it's just an unnecessary waste of energy
2) any change in temperature is disadventageously for stability under load within runtime of refractory lining
Therefore an engineer could start firing a kiln if the TOL is internally announced by mail or phone in advance of written affirmation, if not just leave it as it is.
1st feed to kiln , page-51
-
- There are more pages in this discussion • 24 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Add LYC (ASX) to my watchlist
 (20min delay)
|
|||||
|
Last
$7.89 |
Change
-0.130(1.62%) |
Mkt cap ! $7.374B | |||
| Open | High | Low | Value | Volume |
| $7.97 | $8.02 | $7.86 | $27.21M | 3.442M |
Buyers (Bids)
| No. | Vol. | Price($) |
|---|---|---|
| 3 | 12329 | $7.86 |
Sellers (Offers)
| Price($) | Vol. | No. |
|---|---|---|
| $7.90 | 8744 | 2 |
View Market Depth
| Last trade - 16.10pm 01/10/2024 (20 minute delay) ? |
| LYC (ASX) Chart |