TechW Your Posting is very wide the mark in my view.
The project is a stacked body dipping east to west..see diagram pages 32 and 71 of annual report
Picking 1 hole sho 22 a deep intercept and concluding a substantial overburden ratio is erroneous.
The holes are drilled at 60 degrees to get to approx true width
Review the cross section in the ann report and you will see how it pieces together and makes sense.
Much of the resource outcrops at surface. see photo page 32 ann report
Sh 026 got 76 m from surface at 1.49 g/t Au
BRGM the previous explorers for Gov ..identified an area at surface 30m wide ..500m long that averaged 3g/t Au
Maaden and Brgm did 9000m metres of drilling and established a resource of 1.8 million toones at 3.25 g/t Au equiv adding Ag in
All in the Annual report ..if you dont have a copy on the companys' website
My advice is read before you jump to incorrect conclusions and certainly read the public documents (and if you dont understand them seek geological advice)
Further the Metallurgy and likely recoveries are also summarised on page 35 ann report
Supp and the Chill Ladies..
I would refrain from asking technical advice in these forums..
As a rough rule of thumb (however ,subject to strip ratios, recoveries , met kinetics , throughput etc /etc being normal)...$7.50-$15 per tonne is your raw op cost per tonne of ore mined and processed..or roughly .3 to.5 of a gram Au equivalent
Yours L
CGG Price at posting:
0.0¢ Sentiment: Buy Disclosure: Held