Australia's largest stock trading and investment forum Australia's #1 stock forum

Fencing - Wood Workers - Carpenters, page-4

First 4 Last

Share
Profile

Follow
curiouswon

3,809 Posts.

533

23/07/19

12:46

Post #: 39648862
Share

Originally posted by All4One: ↑

Mark the notch out on the post so you can see it clearly.
Cut down the sides of the notch with a saw untill you get to the lines and no deeper. This should leave ypu with two angled cut lines to work to.
Get a sharp chisel and with the flat side of the blad up against the verticle line tap the chisel and go along the line and make that marking cut a couple of mm deep. Do the same to the pencil line that marks the end of the notch. Then using the chisel just tap lightly back towards ymour chisel lines until clear the cutting away and you should have a good v shaped cut line to work to on both chisel lines.
Working from the side of the post towards the middle start chiseling out the waste being gentle. Keep deepening the cjisel cut lines as you go. Best only take little pieces of wood out at a time.
zYou can also make it quicker and do 5 or 6 cuts twith
the saw the same as the first saw cuts and paralell to the saw cuts this will make the waste wuicket amd easier to remove. Clean up the bottom and sides o f the notch with the chisel keeping. It flat on the bottom of the notch.
Hope ythis helps.

Expand

that is what i meant to say!
3 Upvote

Reply

Top Stories

AII

Almonty locks in govt agreement for tungsten oxide plant in South Korea

NIM

Nimy to raise $1.21M to explore 'newsy' WA targets

MDI

Nanocap Middle Island Resources kicks off Barkly copper-gold drill run – a potential IOCG-style NT project

SKS

SKS Technologies wins US$90M award to supply power to international hyperscale data centre in Melbourne

ASX hits all time high out the gate on Friday trades following bullish US inflation data

I88

Infini soars 50% as company reveals it could’ve just made uranium history – redefining what it means to be “high grade”

BHP

BHP dips as WA nickel suspended after A$6B hit; losses eased by US CPI and forewarning

Week 27 Wrap: ASX hits all time high; CBA shares' two realities; US inflation hits 3% ahead of China plenum

IMM

Immutep reports strong response rate from immunotherapies treating carcinomas

Bitcoin investors need to know the risks

There are more pages in this discussion • 20 more messages in this thread...

First 4 Last