AL3 is the only listed "wire-feed" 3D printing technology on the ASX opposed to "powder-feed" 3D printing. It’s been proven that powder 3D printing can be dangerous and hazardous hence the strict procedures surrounding the storage, transport and use of the metal powders. Wire feed 3D printing uses "wire" that is not hazardous or dangerous and can be easily stored, transported and used without the stringent, costly and time-consuming process needed to be put in place for powder.
The other major advantage that AML3D's wire-feed 3D printing technology presents is that there is a vast number of different grades of metals that are available in "wire" form but not available in "powder" form. This opens doors to a much larger customer base and much larger range of products/contracts that can be tendered for and completed.A simple comparison below between AML3D (A3L) and Amareo (3DA) shows just how big the advantage is over powder.
Amaero (3DA) - Avaliable metals and grades that can be used. (Taken from website).
AML3D (A3L) - Avaliable metals and grades that can be used. (Taken from website).
Ann: Investor Presentation, page-24
-
- There are more pages in this discussion • 40 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Add AL3 (ASX) to my watchlist
 (20min delay)
|
|||||
|
Last
18.0¢ |
Change
-0.010(5.26%) |
Mkt cap ! $68.23M | |||
| Open | High | Low | Value | Volume |
| 19.0¢ | 19.3¢ | 17.5¢ | $428.3K | 2.345M |
Buyers (Bids)
| No. | Vol. | Price($) |
|---|---|---|
| 1 | 10000 | 17.5¢ |
Sellers (Offers)
| Price($) | Vol. | No. |
|---|---|---|
| 18.0¢ | 55083 | 1 |
View Market Depth
| Last trade - 16.10pm 10/10/2024 (20 minute delay) ? |
| AL3 (ASX) Chart |