we are still in for commercial, page-7

My point exactly, this only the first choke, they were just busting to tell everyone how good this was on the first size choke, the uninformed then choked.

Area = Pi x r Squared.

So doubling the diameter for the above (Which is four timing the radius) Gives 4 the area or volume which can can exude from the orifice. There may be a drop in pressure, but note as mentioned in the previous announcement there is an over abundance of it, so the expectation is about 4 times the volume will flow. So expect good results as the choke size is increased. This is normal testing procedure. Showing a lot of good signs here.

Typcally they check every 30 mins until it stabilises, then the rate of production is measured. They wait for the pressures/ volume out to stabilise then monitor for up to 4 hours, then shut in (Close) the hole again and let the pressure build up to static then redo the tests with the next selected size choke until info related to sustainable flow rates is obtained. My opinion only but better to come.