VML General Comments - Chat, page-7692

thanks @Neilsy

this the link me thinks

https://registry.mvlwb.ca/Documents...spection Report - May 10, 2023 - May15_23.pdf

One snippet:

Overall, the camp continues to be adequately managed and this cooperation is appreciated. Mr. Carvelas discussed the relocation of the incinerator, waste transfer area and warming shed for oils & lubes to a strategic location at the T-Zone (Figure 22).

Inspectors have no concerns with this proposal if the required setback of 100 metres for fuel storage can be achieved (Condition #48).

Land use operations at the T-Zone (Figure 23) were discussed and the Inspectors were informed that no further development will occur at this time and only crushed ore will be sorted & bagged for off-site processing. As seen in Figure 24, the Water Settling Pond (WSP) has water present and during last year’s work program the Permittee was constructing the spill way from this engineered structure.

Tardiff Lakes Diamond Drill Program

The drill program finished on approximately April 9th , 2023 and both drills & ancillary equipment were demobilized from the land use area by winter road.

The Permittee drilled seventy-five (75) holes of which sixty-nine (69) were land based and six (6) iced based. The previously noted concerns from the March 14 th , 2023 inspection were satisfactorily addressed and the improvements recommended were implemented.

The area of drilling can be viewed in Figure 25 & 26 and no concerns were noted since all the drill sites were re-visited by site personnel during & after the drill program, no garbage or debris was observed, drill waste disposal did not appear to
be a concern, proper tree disposal occurred, no rutting of the ground surface was present and clearing for both trails and drill pads was kept to a minimum.
Once again, the cooperation of the Permittee & Drill Contractor (Foraco) is appreciated by Inspectors.

what got me is this:

"The camp incinerator will be re‐located to the T‐Zone."

is this due to summer work bagging etc or...???