@Wonkers. Looking back at past discussions e.g., with Reek167, you made a very good point when you said "need quite a lot more mmscfd really" to achieve 5 mmscf/d.
In my opinion, in order to get as close as possible to 5 mmscf, I would pull out all the stops by designing a "mega frac" in the deep high-pressure zone. Provided the frac width is at least 0.5 inch wide, say 1", and the proppant creates good fracture permeability e.g., 500 mD, and the frac wing length is 100 ft or more it should be possible to achieve flow rates close to 5 mmscfd just from this deep high-pressure zone...at least in theory!
Another thing to consider after fracking the well is that it should be possible to operate at higher choke setting than 20/64" to increase the drawdown, which will increase the flow rate.
- Forums
- ASX - By Stock
- EXR
- Ann: Daydream 2 Impressive Initial Flow Test
Ann: Daydream 2 Impressive Initial Flow Test, page-153
-
- There are more pages in this discussion • 62 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Add EXR (ASX) to my watchlist
(20min delay)
|
|||||
Last
11.0¢ |
Change
0.000(0.00%) |
Mkt cap ! $124.7M |
Open | High | Low | Value | Volume |
11.0¢ | 12.0¢ | 11.0¢ | $72.47K | 637.7K |
Buyers (Bids)
No. | Vol. | Price($) |
---|---|---|
11 | 687356 | 11.0¢ |
Sellers (Offers)
Price($) | Vol. | No. |
---|---|---|
11.5¢ | 22726 | 2 |
View Market Depth
No. | Vol. | Price($) |
---|---|---|
5 | 55271 | 0.115 |
12 | 723809 | 0.110 |
7 | 579756 | 0.105 |
16 | 1224298 | 0.100 |
2 | 105550 | 0.099 |
Price($) | Vol. | No. |
---|---|---|
0.100 | 25000 | 1 |
0.115 | 47862 | 4 |
0.120 | 124480 | 5 |
0.125 | 110909 | 2 |
0.130 | 305055 | 4 |
Last trade - 16.10pm 16/07/2024 (20 minute delay) ? |
Featured News
EXR (ASX) Chart |