Essentially agree with you David, but I thought true width was the perpendicular to the plunge of the mineralization. In this case, becUse the plunge is vertical, true width would be a horizontal drill hole, but if it were plunging say 45 degrees west to east, true width would be an intercept at an angle 45 degrees east to west (or 135 degrees west to east. Hope this is not too confusing.
damn, i bought too few pre the halt., page-11
-
- There are more pages in this discussion • 28 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
