Someone been picking cherries? Have a full read "can you just...

Someone been picking cherries? Have a full read "
can you just refute what I say and further provide support
for why you refute it ... would be a welcome change ....?
Right about here, the 260 was an initial clean up during the mplt
prior to lifting the brine ,not a flow rate."


... time & time again you've been wrong, as you are here Cone ... you're probably just trying to extract information, as you don't understand understand what an MPLT is and want to try and childishly say that somehow 260 b/d isn't a flow-rate ... I'm not spoon-feeding you.

... so here is the MAY report again ... but still you think 260 b/d 'isn't' a flow-rate ... lol ... off with the fairies ...

... refer to my reply to a @VOGC post @Raining12 on reported 'surge' etc ... you may learn something [doubtful]

... you may desperately 'want' the well to flow at improved rates ... how's that working out for you ?

... if a post doesn't end in 'this all looks good for the next well' ... then it's rubbish right! @avthold04 ... lol

... mean-while in the real-world -

'ASX ANNOUNCEMENT
15 April 2025
Block 9 Operations Update
Melbana Energy Limited (ASX: MAY) (Melbana)
LR 5.30 (j)The choke size was varied throughout the cleanup flow from 12/64” to
110/64”. During the initial cleanup period, the well flowed naturally and
recovered 216 Barrels of spent acid and completion fluid and 1,894 Barrels
of oil. Whilst surging the well through a 110/64” choke to recover
completion brine, a peak flow rate of 4,167 BPD of total fluid was recorded.
Whilst running the MPLT survey, the well was flowed at an average rate of
260 BOPD through a 32/64” choke for a period of 21 hours. The survey
confirmed that a pump was required to lift the heavy completion brine.
A PCP was run to lift the heavy brine and additional acid pumped. During
the pumping cleanup period, a total of 323 Barrels of completion fluid were
recovered. After cleanup, the well was tested on a fixed pump speed for 12
hours with an average rate of 488 BOPD and 7 BPD of completion brine.'

LR 5.30 (k) The peak flow rate of 4,167 BPD of total fluid was recorded over a 15
minute period at a flowing tubing pressure of 56 PSI.
The average well test flow rate of 488 BOPD was recorded over 12 hours at
a flowing tubing pressure of 7 PSI. [part-of]

... so what part of 'flowed at an average rate of 260 BOPD' don't you understand now ... 'but but MPLT' ... LOL

... the door to 0.010 maybe wide-open ...

... US Sanctions @Kit67 ... maybe secondary US Sanctions ? Iran / Cuba / North Korea / Venezuela ?

... MAY have been performing extremely well operationally imo ...