I’m loading up the base of the hole with a contact adhesive (already had it didn’t buy it specifically), only put in enough to cover bottom of hole by approximately 2-3mm.
Will add a few bits of Cu off cuts and possibly SS bolts/nuts that are buggered in on the next pour of adhesive to reduce volume of adhesive needed.
Was thinking of fashioning 2 plates, top of foot and bottom of folly so I can spread the load a bit.
What do ya reckon?
- Forums
- Lifestyle & Travel
- A Team opinions appreciated
I’m loading up the base of the hole with a contact adhesive...
- There are more pages in this discussion • 17 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Featured News
The Watchlist
BPH
BPH ENERGY LTD
David Breeze, MD & Executive Chairman
David Breeze
MD & Executive Chairman
SPONSORED BY The Market Online