Ann: Bambo-1 well drilling commences offshore The Gambia, page-36

Eve or morning for you Mr P, not a chance mate far too early. Its shale and sands so yes drilling on the bit will be quick ROP but have to factor in setting conductor, drilling out first section then run casing , cement job, run land and test BOP then onto next section bit, drill /run casing etc.....then they might be at point where they are actually drilling into any target. That takes a lot of time mate. Even best teams would struggle to get that done in 10 days. Can't find any well plan on this but pretty sure if they are bullish on first targets they need to get diameter of bore down ( for well control ) so you might find they tear through all targets on 2 short run casing sizes. Add timing factor to any section of interest they will want to run tools down so pull BHA , rig for wireline, back in hole its shallow so all told 24 hrs unless they decide to take cores or even RFT on specific sections of interest which is a second run of the tools, then back out and back in with BHA. Takes a lot of time to get into depths of any mature sections then lot more to see what they may or may not have. MWD or LWD has moved light years in last decade but they still don't touch the bore so are limited on the results they give. Pretty sure FAR will want every piece of info on porosity/sands etc etc from each and every section to correlate seismic on block so I expect reasonable time wirelining. Hope this helps, slainte.