@Wonkers. Looking back at past discussions e.g., with Reek167,...

@Wonkers. Looking back at past discussions e.g., with Reek167, you made a very good point when you said "need quite a lot more mmscfd really" to achieve 5 mmscf/d.

In my opinion, in order to get as close as possible to 5 mmscf, I would pull out all the stops by designing a "mega frac" in the deep high-pressure zone. Provided the frac width is at least 0.5 inch wide, say 1", and the proppant creates good fracture permeability e.g., 500 mD, and the frac wing length is 100 ft or more it should be possible to achieve flow rates close to 5 mmscfd just from this deep high-pressure zone...at least in theory!

Another thing to consider after fracking the well is that it should be possible to operate at higher choke setting than 20/64" to increase the drawdown, which will increase the flow rate.