Australia's largest stock trading and investment forum Australia's #1 stock forum

OZM ozaurum resources limited

2.99%

6.5¢

Yeah, my mistake on MG10 haha! Please note everyone that I stand...

First 167 Last

Share
Profile

Follow
Paul88

1,796 Posts.

570

04/06/25

22:57

Post #: 79319899
Share
Originally posted by Hateful8: ↑

Nah, nothin to see here chap! Cheers Big Ears... gltah h8tey

1. Cross-Section Analysis for MG-10 and MP-14
MG-10
Location: MG-10 is 125 meters north along strike of the Cross Fault "hot spot," which we know from prior discussions is 1.3 km south of the 260,000-ounce resource (0.7 g/t) and has high-grade intercepts like 48m at 1.66 g/t (MNORC 221).
Cross-Section Details (Report 019849, Page 13):
MG-10 intersected 25m at 2.00 g/t Au from 25m to end-of-hole (EOH) at 50m depth, ending in mineralization.
From Report 39210 (Page 17), MG-10’s coordinates are 12600N, 10400E, with a depth of 50m, and it returned 25m at 1.36 g/t Au from 25m (slightly lower grade than the 2.00 g/t stated, possibly due to different assay methods or reporting discrepancies).
Geological Context:
MG-10 is within the felsic volcaniclastic suite near the contact zone with mafic rocks to the east, a key exploration target (Report 39210, Page 11). This contact zone features strong shearing, quartz-carbonate veining, and anomalous arsenic, typical of gold mineralization at Mulgabbie.
The mineralization is likely associated with quartz stockworks or large quartz veins, as described in both reports (e.g., Report 019849, Page 9: gold in quartz veining with sericite-carbonate alteration).
Potential Beyond 50m Depth:
Since MG-10 ends in mineralization (25m at 2.00 g/t), there is a strong likelihood of continuity at depth. The Cross Fault’s high-grade intercepts (e.g., 48m at 1.66 g/t) extend to ~127m depth (e.g., MNORC 221’s 10m at 1.80 g/t from 127m), suggesting mineralization in this system persists to at least 100–150m.
The structural setting (north-south faults, northeast cross-faults) supports deeper mineralization, as faults act as conduits for gold-bearing fluids (Report 39210, Page 11).
Report 019849 (Page 13) notes near-surface depletion and supergene enrichment at depth (e.g., 9m bench at Jack’s Show averaged 6.79 g/t over 7m), indicating gold grades may improve below the oxidized zone (~50m depth in MG-10).
MP-14
Location: MP-14 is ~400m north along strike from MG-10, placing it ~525m north of the Cross Fault hot spot and ~775m south of the main 260,000-ounce resource.
Cross-Section Details (Report 39210, Page 17):
MP-14 is at 12600N, 10375E, with a depth of 50m, and returned:
2m at 1.85 g/t Au from 42m.
2m at 2.25 g/t Au from 46m to EOH, ending in mineralization.
Report 019849 (Page 10) references MP-14 (as MG-14) in the trial mining area at 12530N, 10140E, with 8m at 0.31 g/t Au from 24m, indicating a discrepancy in naming or location. For consistency, we’ll use Report 39210’s data (MP-14 at 12600N, 10375E).
Geological Context:
MP-14 is also near the mafic-felsic contact zone, with similar structural controls (quartz veining, shearing). The mineralization style matches MG-10, with quartz veins hosting gold (Report 019849, Page 12).
The trial mining at Jack’s Show (12530N, 10140E) showed supergene enrichment at depth (e.g., 6.79 g/t over 7m at 9m depth), suggesting potential for higher grades below MP-14’s 50m depth.
Potential Beyond 50m Depth:
MP-14 ends in mineralization (2m at 2.25 g/t), indicating potential for deeper gold. The narrow intercepts (2m) suggest a more focused vein system compared to MG-10’s wider zone, but the structural setting supports continuity.
The nearby MP-15 (6m at 1.31 g/t from 27m, Report 019849, Page 10) is 15m deeper than the trial pit’s high-grade zone, suggesting the shoot may plunge west or have limited extent. However, the Cross Fault’s deeper intercepts (e.g., 127m) indicate potential to at least 100–150m depth.
Potential Beyond 50m Depth for Both Holes
Depth Continuity: Both MG-10 and MP-14 end in mineralization at 50m, within the oxidized zone. Report 019849 (Page 11) highlights supergene enrichment at depth (e.g., 9m bench at Jack’s Show), and Cross Fault drilling shows mineralization to ~127m, suggesting both holes could intersect higher grades below 50m, likely in the 50–100m range.
Grade Potential: MG-10’s 25m at 2.00 g/t is already economic, and deeper drilling could encounter wider or higher-grade zones, as seen at Cross Fault (e.g., 12m at 4.26 g/t). MP-14’s narrower intercepts (2m at 2.25 g/t) may widen or improve with depth, as supergene processes often concentrate gold near the weathered-unweathered interface (~50–70m).
Structural Support: The Relief Shear’s north-south faults and northeast cross-faults (Report 39210, Page 10) provide conduits for gold fluids, increasing the likelihood of deeper mineralization along strike and down-dip.
2. Potential to Add Ounces Along Strike and at Depth
Strike Continuity:
MG-10 (125m north of Cross Fault) and MP-14 (525m north of Cross Fault) lie along the Relief Shear corridor, which spans 2.2 km (and potentially 8 km, as per prior discussions). The 400m gap between MG-10 and MP-14, and the 125m gap to Cross Fault, suggest mineralization continuity along strike.
Cross Fault’s 400m strike length (e.g., 10m at 1.80 g/t) and the 2.2 km mineralized zone (2021 data) indicate a large system. MG-10 and MP-14’s hits align with this trend, supporting potential for additional ounces over a ~525m strike length (Cross Fault to MP-14).
Depth Potential:
Extending MG-10 and MP-14 to 100–150m depth could add significant ounces if mineralization persists. For example, if MG-10’s 25m at 2.00 g/t extends another 50m at similar grade, it could add ~25,000 ounces over a 50m strike length (assuming a 5m width and 2.7 t/m³ density).
MP-14’s narrower zones might add fewer ounces (~5,000–10,000 over a similar depth extension), but the potential for wider zones at depth (as seen at Cross Fault) increases the upside.
Total Potential:
A 525m strike length (Cross Fault to MP-14) with an average 20m width (based on MG-10 and Cross Fault), 100m depth, 1.5 g/t grade (conservative average), and 2.7 t/m³ density yields ~210,000 ounces. This rough estimate highlights the potential to “quickly add ounces” if continuity is confirmed.
3. Support from Western Reefs Reports for Deeper Mineralization
Probability Basis
Geological Evidence:
Supergene Enrichment: Report 019849 (Page 11) confirms near-surface depletion and supergene enrichment at depth (e.g., 6.79 g/t over 7m at 9m depth in Jack’s Show trial pit). This supports a high probability (>80%) of improved grades below 50m in MG-10 and MP-14, as both are in the oxidized zone.
Structural Controls: Both reports (e.g., Report 39210, Page 11) highlight fault-controlled mineralization along the mafic-felsic contact, with quartz veining and shearing. The Cross Fault’s deeper hits (127m) align with this model, increasing confidence (70–80% probability) in deeper mineralization.
Historical Assays: Report 019849 (Page 13) notes other RC holes with similar grades at depth (e.g., MG-8: 18m at 1.78 g/t from 18m; MG-10: 25m at 1.36 g/t from 25m), suggesting a consistent mineralized system. The trial pit’s high grades at depth further support this (80% probability of economic grades below 50m).
Drilling Limitations:
Report 019849 (Page 13) highlights that small-sample assays (20g) may downgrade gold content compared to larger samples (e.g., 500g), and “bottle roll” assays didn’t significantly upgrade RC results. This introduces some uncertainty (~20%) in grade estimates but doesn’t negate the potential for deeper mineralization.
Overall Probability: The reports support a 75–85% probability of significant gold mineralization beyond 50m depth, driven by supergene enrichment, structural controls, and historical data.
Specific Areas
Mafic-Felsic Contact Zone (Relief Shear):
Both reports emphasize the contact zone between mafic and felsic rocks as the primary target (Report 39210, Page 11; Report 019849, Page 9). MG-10 and MP-14 are within this zone, along the Relief Shear, which hosts the Cross Fault discovery.
The contact zone extends north-south across the tenements (P28/784–787), with the western contact (felsic-ultramafic) also prospective but less explored (Report 39210, Page 11). This western contact, north of the tenements, is mineralized and could be a target for deeper drilling.
Jack’s Show Area (12530N, 10140E):
Report 019849’s trial mining at Jack’s Show (12530N, 10140E) showed high grades at depth (6.79 g/t over 7m at 9m), near MG-14 (MP-14 in Report 39210). This area, ~400m south of MG-10, confirms deeper potential along strike.
The pipe-like shoot at Jack’s Show remains open to the west, suggesting lateral and depth extensions (Report 019849, Page 12).
Cross Fault to MP-14 Corridor:
The 525m strike length from Cross Fault to MP-14, along the Relief Shear, is the key area for adding ounces. The reports’ focus on fault-controlled mineralization and quartz veining supports deeper potential in this corridor, particularly between 12600N (MP-14) and 14300N (near the main resource).
Western Contact Zone:
Report 39210 (Page 11) recommends RAB drilling to test the western contact (felsic-ultramafic), which is mineralized to the north. This area, potentially west of 10140E, could host deeper mineralization if extended southward into the tenements.
4. Conclusion
Potential Beyond Depth:
MG-10 (25m at 2.00 g/t to 50m) and MP-14 (2m at 2.25 g/t to 50m) both end in mineralization, with a high likelihood (75–85%) of economic grades below 50m, potentially to 100–150m depth, based on supergene enrichment (Report 019849) and Cross Fault precedents.
Strike Continuity:
The 525m corridor from Cross Fault to MP-14 along the Relief Shear could add ~210,000 ounces if mineralization persists at depth and along strike, supporting the potential to “quickly add ounces.”
Support from Reports:
The Western Reefs reports strongly support deeper mineralization (75–85% probability) through evidence of supergene enrichment, fault-controlled quartz veining, and historical drilling. Key areas include the mafic-felsic contact zone (Relief Shear), Jack’s Show (12530N, 10140E), the Cross Fault to MP-14 corridor (12600N–14300N), and the unexplored western contact zone.
Next Steps:
Extend MG-10 and MP-14 to 100–150m depth to test for deeper mineralization.
Infill drilling along strike (e.g., every 50–100m between Cross Fault and MP-14) to confirm continuity.
Test the western contact zone with RAB drilling, as recommended in Report 39210, to explore additional deeper targets.

Expand

Yeah, my mistake on MG10 haha! Please note everyone that I stand corrected - I went back and checked Report 19849 so yes its 25m @ 1.36 g/t from 25m! This report is also interesting because of the trial mining that went on at Jack's Show which is about 200m north along strike from MP-14. Well worth a read I reckon if you've got the time. AIMHO (DYOR).
OZM Price at posting: 8.1¢ Sentiment: Hold Disclosure: Held
3 Upvote

2 Great analysis

Reply

Top Stories

Listen: HotCopper Wire Podcast 014 – Abu Dhabi wants to buy our 'true' oil and gas gem

ASX Market Close: Middle East War rattles investors | June 23, 2025

Markets were expecting Trump to bomb Iran. It's just another new normal

SFX

Sheffield Resources spruiks 'pleasing' maiden MRE at South Atlantic Project

Uranium ignites: Is this the start of a supercycle?

First 167 Last

Add to My Watchlist

What is My Watchlist?

A personalised tool to help users track selected stocks. Delivering real-time notifications on price updates, announcements, and performance stats on each to help make informed investment decisions.

(20min delay)
Last 6.5¢		Change -0.002(2.99%)		Mkt cap ! $14.89M

Open	High	Low	Value	Volume
7.3¢	7.4¢	6.5¢	$53.80K	814.0K

Buyers (Bids)

No.	Vol.	Price($)
1	145702	6.5¢

Sellers (Offers)

Price($)	Vol.	No.
7.0¢	45000	1

View Market Depth

No.	Vol.	Price($)
1	145702	0.065
2	181120	0.062
2	123967	0.061
1	16660	0.060
2	104000	0.058

Price($)	Vol.	No.
0.070	45000	1
0.074	32787	2
0.077	2000	1
0.078	64307	2
0.080	48288	1

Last trade - 16.10pm 23/06/2025 (20 minute delay)

OZM (ASX) Chart