Prob the prob is the time setting the machine up....if its a heap of the same welding it should be ok..
They could also use it to do multipass runs.?
Or is it for one run only up to 16mm single run only
Then again heat input comes into it allso..
Making odd size beams it would work..
Do the have a jig system in place for distorsion?what distorsion do they get from doing this is a big question????
Need to explain it a bit better to market.
Market just gussing at the moment i assum.
Just my ramblings here.
- Forums
- ASX - By Stock
- Ann: Investor Presentation
Prob the prob is the time setting the machine up....if its a...
-
- There are more pages in this discussion • 28 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Add KTG (ASX) to my watchlist
(20min delay)
|
|||||
Last
14.5¢ |
Change
0.000(0.00%) |
Mkt cap ! $10.63M |
Open | High | Low | Value | Volume |
0.0¢ | 0.0¢ | 0.0¢ | $0 | 0 |
Featured News
KTG (ASX) Chart |
Day chart unavailable