haven't been reading all the posts as on holiday and there are a lot of posts so sorry if some has posted this before. My understanding is as follows taken from a recent presso. Any thought / corrections?
-spud 24/9 - tick- -drill and Run In Hole (RIH)conductor to ~60m and cement to surface in place (assume complete)- -drill 17.5 inch hole to ~650-700m ( just above 200) (assume in progress) - run 13.38 Incan casing and cement to surface - wait on cement and BOP adjustment - drill out cement, casing shoe - adjust drilling fluid and get higher mudweight,, - perhaps they run a cement bond log? - Leak of Test respectively formation integrity test - perform kick drills and then drill slowly and carefully (because IVZ sees the risk of an overpressured 200 formation - drill through the 200 (complete 14-17 days from spud) - drill to base of 400 (~2200m) (10-15 days) - wireline logging (3-5 days)- so first definitive results ~ 27-37 days from spud - Case the first section (~ 7 days) - 8.5 inch hole through the pebbly arches to TD (~10 days) - wireline logging of bottom section (3-5 days) - results from bottom section ~50-60 days from spud - first results roughly 21-30 October - second results roughly 14-24 November - unless there is a kick then on for young and old.
