haven't been reading all the posts as on holiday and there are a...

haven't been reading all the posts as on holiday and there are a lot of posts so sorry if some has posted this before. My understanding is as follows taken from a recent presso. Any thought / corrections?

-spud 24/9 - tick-
-drill and Run In Hole (RIH)conductor to ~60m and cement to surface in place (assume complete)-
-drill 17.5 inch hole to ~650-700m ( just above 200) (assume in progress)
- run 13.38 Incan casing and cement to surface
- wait on cement and BOP adjustment
- drill out cement, casing shoe
- adjust drilling fluid and get higher mudweight,,
- perhaps they run a cement bond log?
- Leak of Test respectively formation integrity test
- perform kick drills and then drill slowly and carefully (because IVZ sees the risk of an overpressured 200 formation
- drill through the 200 (complete 14-17 days from spud)
- drill to base of 400 (~2200m) (10-15 days)
- wireline logging (3-5 days)- so first definitive results ~ 27-37 days from spud
- Case the first section (~ 7 days)
- 8.5 inch hole through the pebbly arches to TD (~10 days)
- wireline logging of bottom section (3-5 days)
- results from bottom section
~50-60 days from spud
- first results roughly 21-30 October
- second results roughly 14-24 November
- unless there is a kick then on for young and old.