Also note as per below overlap graph, 100% of these parcels fall...

Also note as per below overlap graph, 100% of these parcels fall within the Alluvial Fans.







According to that West - East cross section line, Hole #5 is sitting right on it. Hence the results so far are corroborating below Geological Model perfectly. There is 500m thickness of deep sand unit in Hole #5.


I we drill Hole #6 ~3km to the West following that cross section line (i..e. Southest point of Silvia Irene), as per below, no Halite and also 500m thickness of Deep Sand.



This graph above shows LEL is in the right side of the SALAR. Accesible high and thick DEEP SAND unit. Lithium Americas, is in the wrong side, mostly Clay and Halite (low yield). Allkem in the middle is good, and good grades, although a lot of Halite with low yield, hence their JORCS show full averages of ~5% yield.




Then moving into the South-North cross section line, there is again a perfect match of the geological model to the Hole #3. As per below overlap of model and Hole #3 lithology. Hole #3 found 220m oh Halite (pink in the lithology and brown in the chart) and 90m of DEEP SAND. You can clearly see below this was 90m of Sand was only the beginning of 300m of DEEP SAND to basement.









It is critical to continue drilling on Hole 2, and further inland to the center of the parcel.

FFALINGS, when you add the above assumptions to the SAND UNIT thickness, the JORC goes up in multiples. roughly 2Mt per 100m of Deep Sand unit.

I will do a different post on grades. Cheers team.