Share
4,528 Posts.
lightbulb Created with Sketch. 4
clock Created with Sketch. 14/03/17
18:45
Share
Originally posted by Club_sharer
↑
You don't need any angle on the torque converter if there's a drain plug in it - remove the cover on the front lower side of the bell housing - usually 2 small bolts. With a long screw driver, turn the engine over by pushing against the ring gear (ring gear is what the starter meshes). The drain plug is a 7/16 or 11 mm size, and undoing it will release about a litre and a half. If it's not there, then it's not the end of the world.
Expand
Band nut... OK I was expecting more out of the torque converter than 1 quart... TThought there would be some higher angle to accommodate for the blades in the torque converter...
