https://hotcopper.com.au/posts/60375881/single
Basically, the above simple analysis takes the most viscous oil and extrapolates psi/ft (pressure drop v flow rate data) for the most viscous oil on the chart at 250gal/min and applies fluid laws to it to get the pressure loss at greater flow rates in a 4” tube.
It shows that provided the oil can flow from the reservoir into the slotted liner and production tube 20k bopd with 8500 Psi reservoir pressure to spare then that’s enough to get that much 600SSU oil to surface - yes 20k BOPD.
And given our huge mammoth net pays, vuggy porosity, dual fracture matrix, I wouldn’t be at all surprised if it’s this simple.
Yes, I’m excited after waiting 26 months for this but there is a degree of science, that I’m confident of, to support it and I take it seriously.
This however, is not advice and I’ve qualified myself many many many times as a non-O&G mechanical engineer. Simply sharing my musings.
good luck
MAY Price at posting:
7.3¢ Sentiment: Buy Disclosure: Held
