Efficient solar energy storage for light and dark conditions

Efficient solar energy storage for light and dark conditions

A photoelectrochemical cell using all-vanadium redox species could offer efficient and large-scale solar energy storage, even under dark conditions.
29 September 2015, SPIE Newsroom. DOI: 10.1117/2.1201509.006110

​

Sunlight is one of the most abundant renewable energy sources, and the ability to harness it offers a sustainable solution to energy shortages. Despite this potential, however, conventional solid-state solar cells can generate only intermittent power. One alternative is chemical fuel (for example, hydrogen) produced by artificial photosynthesis, which offers the promise of converting and storing solar energy. Thus far, no such schemes have been realized commercially because of major shortcomings, for example, low efficiency and poor storage options for hydrogen.
To overcome these problems, we developed an all-vanadium photo-electrochemical storage cell (all-V PESC)^1–4 to improve the efficiency of large-scale solar energy storage schemes. Figure 1 shows potential application of the system. Our design takes advantage of reversible redox reactants, namely, vanadium redox. These remain in liquid form during photocharge and discharge, and are therefore advantageous for easy storage and high capacity. Most importantly, when combined with an electrode hybrid of tungsten(VI) oxide (WO₃) or titanium dioxide (TiO₂), the cell offers good reversibility, significant improvement in photocurrent, and high-capacity electron storage,^{2, 3} which could enable continuous solar energy storage, even under dark conditions.
mce-anchor
Figure 1. Schematic of the all-vanadium photoelectrochemical storage cell (all-V PESC), which would work under both light and dark conditions. Solar energy is stored during the day in the form of chemical energy in the storage tank. The electrons, stored using a hybrid electrode, continue solar energy conversion even under dark conditions. At night, the stored energy is converted to electricity using a flow battery.
Previously, we showed^2,3 how we could enable electron storage by a phenomenon called photochromism.^{5, 6} We found that, in a typical WO₃/TiO₂ hybrid electrode, formation of hydrogen tungsten bronze (H_xWO₃) is responsible for both reversible electron storage and release, under light and dark conditions, respectively. The amount of stored electrons is proportional to WO₃ content in the hybrid electrode. Recently, we also discovered a synergy between vanadium redox and reversible electron storage in the all-V PESC.³
To understand the electron storage mechanism, we investigated three electrolyte (anolyte and catholyte) combinations in an experimental photoelectrochemical (PEC) storage cell: see Figure 2(a). First, we employed 3 M of sulfuric acid (H₂SO₄) as both the anolyte and catholyte: see Figure 2(b). Second, we formed an all-V PESC using all-vanadium electrolytes and WO₃/TiO₂ hybrid electrodes with different WO₃ content: see Figure 2(c). When coupled with vanadium redox species in an all-V PESC, the WO₃/TiO₂ hybrid electrode (with 24wt% WO₃ content) offers long-term electron storage, good storage reversibility, and significant improvement in both photocurrent and dark current (resulting from release of the stored electrons). Finally, to distinguish the scavenging effects of holes and electrons by vanadium redox in electron storage, we used vanadium redox species only as either the anolyte or catholyte in the PEC storage cell. Figure 2(d) shows the photocurrent curve for the all-V PESC when we swapped the 0.01M V³⁺ catholyte (using a hybrid electrode with 24wt% WO₃) for 3M H₂SO₄ at the counter electrode—the black curve in Figure 2(d)—while the anolyte remained the same. We observed a significant reduction in both photocurrent and dark current, compared with the case when only the anolyte was replaced: shown in the red curve in Figure 2(d).
mce-anchor
Figure 2. Photoelectrochemical (PEC) response of a storage cell under both light and dark conditions. (a) Illustration of the all-V PESC. PE: Photoelectrode. CE: Counter electrode. VO₂⁺, VO²⁺, V²⁺, V³⁺: Vanadium electrolyte combinations. e: Electrons. (b) Photocurrent I(mA) curves using tungsten(VI) oxide (WO₃)/titanium dioxide (TiO₂) hybrid photoelectrodes with different WO₃ content. A: Anolyte. C: Catholyte. 3M H₂SO₄: Sulfuric acid at 3M concentration. (c) Photocurrent curves of an all-V PESC using WO₃/TiO₂hybrid photoelectrodes with different WO₃ content. (d) Photocurrent curves of a WO₃/TiO₂hybrid electrode (24wt% WO₃) using different combinations of electrolytes.
These results confirm that PEC water-splitting reactions, especially the oxygen evolution reaction, are sluggish compared with those involving vanadium redox, primarily because reduction and oxidation of water are complex multi-step reactions that require significant overpotential. Most importantly, our results show that when we use the vanadium redox species as the catholyte, it boosts electron transfer kinetics, and plays a critical role in reversible electron storage. We confirmed this by different photoelectrode coloration after illumination:³ blue-black appeared on the electrode in pure acid electrolytes, while in vanadium redox electrolyte, the electrode appearance remained unchanged, indicating fast decomposition of H_xWO₃, and thus quick release of the stored electrons.
Figure 3 shows the working principle of in situ electron storage and release with the aid of vanadium redox, enabling solar energy conversion under dark conditions. Under light, the fast vanadium redox reaction (VO₂⁺/VO²⁺) efficiently consumes photogenerated holes, suppressing charge recombination, and enabling electron storage in H_xWO₃. Furthermore, the fast reaction kinetics of the V³⁺/V²⁺ redox helps boost the photocurrent. In the dark, decomposition of H_xWO₃ in the photoelectrode releases electrons, which flow in the same direction as the photocurrent under light. The kinetics of electron release are enhanced by the fast PEC reaction of V³⁺/V²⁺ redox, which proceeds in the same way as that under light. In other words, the solar energy storage reaction continues even under dark conditions.
mce-anchor
Figure 3. Schematic of an all-V PESC that works under both light and dark conditions. The electron storage mechanism enabled by the all-vanadium redox is shown. The electrons stored under light in a hybrid electrode are released automatically in darkness, allowing the device to keep functioning. H_xWO₃: Hydrogen tungsten bronze. e^-: Electron. h⁺: Hole.
In summary, we have shown that an all-V PESC using a hybrid photoelectrode represents a promising system for efficient and large-capacity solar energy storage, which potentially works in both light and dark. The role of vanadium redox, particularly the V³⁺/V²⁺ anolyte, is essential for good electron storage reversibility, and significant improvement in both photocurrent and dark current. This therefore improves the overall solar energy storage efficiency and the effectiveness of cell operation. In future work, we will focus on using more advanced materials to develop versatile and high-performance solar energy storage systems.

http://spie.org/x115487.xml?highlight=x2358&ArticleID=x115487

VRB in da house! Just a matter of time before the SP vertical! I dunno when that time is though..