Australia's largest stock trading and investment forum Australia's #1 stock forum

Firstly, I messed up. I didn't see the holes I should have seen....

First 696 Last

Share
Profile

Follow
jwt

3,702 Posts.

101

12/05/22

20:01

Post #: 61376983
Share

Originally posted by wotsup: ↑

no no..there are holes drilled in the bottom of the horizontal pipeNormally you place the holes part way off the bottom as your trying to encourage water to come out of all holes at the same time, (hence spreader).
You also partially seal off the lower end of your horizontal.

going to silicone along the entire length of the flashingGenerally as a rule, no silicone as it can be your worst enemy.
Water at times gets in and then cannot get out, due to the silicone.
If your going to use it, use plenty and work it in with your finger, in a circular motion.

Expand

Firstly, I messed up. I didn't see the holes I should have seen. Hense, no spreader. But now you clarify that there are. So hense, a spreader. And wotshisname is correct; normally the holes are visible from where your photo is taken.
3 Upvote

Reply

There are more pages in this discussion • 671 more messages in this thread...

First 696 Last