Hi Freddie,In the diagram lifted from the ann, DDH3 is closer to...

Hi Freddie,
In the diagram lifted from the ann, DDH3 is closer to RC199 (and previous RC holes 95 and 98).
DDH3 was about 250m deep and was testing below previous RC holes (last year and the year before - i'd have to go back and look).
DDH4 has been stepped back from DDH3 and will drill under DDH3 to test structures at depth (drilling to 90 degrees, so towards the East). They did the same thing at Crusader with DDH1 and 2. Not much was reported from DDH2 but i recall Andy saying it was [Sic] " ... an important hole in terms of modelling."

Results from DDH3 could be between 1-4 weeks away depending on the labs. Apparently the long delays in assays in WA has picked up a bit recently. Nexus uses Intertek in Perth so i'm not sure how they are going.

Note, i previously mentioned Branches would be the subject of a DDH but i think i stuffed that up, sorry. I can only find references to Crusader, Templar and Paint.

I might try and map the current holes if i get a chance as i did map many from 2020 and 2019. I could then load the KML file into Google Earth and do a fly over. Happy to share the file with others once it's done. I'll throw up a post and let you know once finished as these things take around a full eight hours to do. Mrs Perdant may not be happy with that all happening in one day!

I did a few of these for our other company. The KML file is interactive and you can click on each hole to reveal data.
Here are two examples:

https://hotcopper.com.au/posts/38403903/single

and


Hope that helps,
Perdy