oil & gas expert opinions required - thank u , page-13

For those "non experts", one to bookmark...Schlumberger

http://www.glossary.oilfield.slb.com/default.cfm

So much attention is being given to the P&A in the ann. and no flow testing/flaring. How about "as per the approved drilling program and best practice."

WIRELINE LOG
"A continuous measurement of formation properties with electrically powered instruments to infer properties and make decisions about drilling and production operations. The record of the measurements, typically a long strip of paper, is also called a log. Measurements include electrical properties (resistivity and conductivity at various frequencies), sonic properties, active and passive nuclear measurements, dimensional measurements of the wellbore, formation fluid sampling, formation pressure measurement, wireline-conveyed sidewall coring tools, and others. In wireline measurements, the logging tool (or sonde) is lowered into the open wellbore on a multiple conductor, contra-helically armored wireline. Once lowered to the bottom of the interval of interest, the measurements are taken on the way out of the wellbore. This is done in an attempt to maintain tension on the cable (which stretches) as constant as possible for depth correlation purposes. (The exception to this practice is in certain hostile environments in which the tool electronics might not survive the temperatures on bottom for the amount of time it takes to lower the tool and then record measurements while pulling the tool up the hole. In this case, "down log" measurements might actually be conducted on the way into the well, and repeated on the way out if possible.) Most wireline measurements are recorded continuously even though the sonde is moving. Certain fluid sampling and pressure-measuring tools require that the sonde be stopped, increasing the chance that the sonde or the cable might become stuck. Logging while drilling (LWD) tools take measurements in much the same way as wireline-logging tools, except that the measurements are taken by a self-contained tool near the bottom of the bottomhole assembly and are recorded downward (as the well is deepened) rather than upward from the bottom of the hole (as wireline logs are recorded)."