No sweat gonz.
To take your analysis further :)
Drilling so far on other aus co's:
Aspire (AKM):
""Infill Drilling Identifies Thick, Near-Surface Coal
Infill drilling commenced at the Ovoot Coking Coal Project in March 2011. Three holes have
now been completed as shown on Figure 1.
DH 246 Upper Seam 35.6 metres of coal from 123.2 metres
Lower Seam 9.8 metres of coal from 212.4 metres
DH 247 Upper Seam 24.1 metres of coal from 83.5 metres
Upper Seam 37.2 metres of coal from 114 metres
Lower Seam 23.5 metres of coal from 219.5 metres
DH 248 Upper Seam 22.8 metres of coal from 98.9 metres
Lower Seam 9.4 metres of coal from 164.7 metres
All holes were cored through the coal seams to provide further samples for quality analysis.""
Hunnu (HUN) :
""At the end of April the Company had six drilling rigs operating on the Project and had drilled 44,243 metres from 278 holes. The Company has discovered a semi continuous coal seam with over eight kilometers of strike length and the entire system remains open with some of the better drilling results only recently being completed. Coal has been intersected less than ten metres from surface with a combined seam thicknesses of approximately 30 metres.""
Just a snippet from their ann's ~ dyor to make sure!
Well, Mark's are doing very nicely for us, eh !
CEO :
""�h 60m coal seam intersected from surface on first drill hole in Ovorhangay Province
�h Second hole intersected 40m coal seam at open pit mineable depth
�h Drill core review indicates significant section of high quality coal""
Also, check HUN's web reports - we Aus co's are 'miles' behind m/cap of our nth american or Mono companies!
Yes, imo, the view from the 'crowsnest' is ....
Cheers :)
- Forums
- ASX - By Stock
- seams like a mongolian dream
No sweat gonz.To take your analysis further :)Drilling so far on...
-
- There are more pages in this discussion • 2 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)