VUD15 was drilled at 80 degree inclination towards southwest. Hole completed at 1378m. Assayed average 1.69% Cu and 1.05g/t gold at depth of 1310m to 1333m.
VUD18 drilled to 1675m with azimuth 200 degrees. So VUD18 will intersect above zone in VUD15. By end of hole, inclination down to 33 degrees. So if this inclination was achieved just before the 1310m , then VUD18 is going to pick up a lot more metres passing on the diagonal through the 1310 to 1333 zone of VUD15. So will shed a lot of data on that zone.
The zone in VUD15 is vertically approx 32.5m vertical depth (calculate using sine 80 degrees).
If VUD 18 transects this zone at 33 degrees off the horizontal, then it's horizontal length in this zone would be found by tan 57 X 32.5m = 1.53 X 32.5 = 50 m.
The actual length of VUD18 in the zone would be vertical height divided by sine 33 = 32.4/0.544 = 59m
All should be interesting if my maths is OK. Results should be out soon, hopefully.
- Forums
- ASX - By Stock
- TAS
- VUD15 and VUD18
VUD15 and VUD18
-
- There are more pages in this discussion • 63 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Add TAS (ASX) to my watchlist
(20min delay)
|
|||||
Last
0.5¢ |
Change
0.000(0.00%) |
Mkt cap ! $4.026M |
Open | High | Low | Value | Volume |
0.0¢ | 0.0¢ | 0.0¢ | $0 | 0 |
Featured News
TAS (ASX) Chart |
Day chart unavailable