@Hello2U
set up for machining
that helps explain this pic. Blade on bench drill fixed at correct height, then clamping the pin on the table - still not separated from the thread rod
( and moving it to the desired depth ) .
- Forums
- DJPIN
- Wednesday 21st JULY ...Goblins close enough
Wednesday 21st JULY ...Goblins close enough, page-74
-
- There are more pages in this discussion • 13 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Featured News
The Watchlist
SS1
SUN SILVER LIMITED
Gerard O'Donovan, Executive Director
Gerard O'Donovan
Executive Director
SPONSORED BY The Market Online