yep have used on a floor that went from 90mm thick to 250mm thick to level up for workshop benefits were that it made the 32mpa 20 mm concrete a lot more viscous even at 90 slump no mesh as was on a stable base [just cut concrete where original cuts underneath ]] minimal cracking even though large machines running on it , very easy to finish
Who is using Edencrete., page-3
-
- There are more pages in this discussion • 1 more message in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Add EDE (ASX) to my watchlist
 (20min delay)
|
|||||
|
Last
0.2¢ |
Change
0.000(0.00%) |
Mkt cap ! $8.216M | |||
| Open | High | Low | Value | Volume |
| 0.0¢ | 0.0¢ | 0.0¢ | $0 | 0 |
| EDE (ASX) Chart |
Day chart unavailable