I’m loading up the base of the hole with a contact adhesive (already had it didn’t buy it specifically), only put in enough to cover bottom of hole by approximately 2-3mm.
Will add a few bits of Cu off cuts and possibly SS bolts/nuts that are buggered in on the next pour of adhesive to reduce volume of adhesive needed.
Was thinking of fashioning 2 plates, top of foot and bottom of folly so I can spread the load a bit.
What do ya reckon?
- Forums
- Lifestyle & Travel
- A Team opinions appreciated
A Team opinions appreciated, page-43
- There are more pages in this discussion • 17 more messages in this thread...
You’re viewing a single post only. To view the entire thread just sign in or Join Now (FREE)
Featured News
Featured News
The Watchlist
RDN
RAIDEN RESOURCES LIMITED
Dusko Ljubojevic, MD
Dusko Ljubojevic
MD
SPONSORED BY The Market Online