And did anyone pick up on the red lines on the factory floor...

And did anyone pick up on the red lines on the factory floor inside which were at least a couple of separators? This bit;



From a video in early October last year. Not aware that anyone said wtf is happening here...... though I did point it out to she who matters on the day. They're even in a red box, inside a red square. At that time in early October, based on one of my chats with a couple of blokes after the AGM in late November I can only presume that the external manufacturer had assured Redflow that all was in hand, again. By this stage, early October, Redflow must have been at least 4 months into exploring alternative processes. But it was still happening then. Pretty impossible to mechanise, automate, when crud like this was still being sent to Redflow.

Regarding Anaergia, check out their financial health in the USA, I did in trying to figure out what might be happening last year. Perhaps a couple of months later it was covered at the AGM, in response to a question from someone else on the floor, one of those projects not likely to happen. Smaller cheese, spilt milk etc. By that time there was enough else happening. It was sad but the Anaergia site was fully functional long enough, with enough feed stock, to make a difference for Redflow. My own view, and I think this is what is happening as a beginning, follow up on, concentrate on, projects where the end user (or the sponsor) is less likely to go bye byes, like these ones...... You only need so many reference projects, or key people, on your side but it takes time.


My selection from slide 4 in https://wcsecure.weblink.com.au/pdf/RFX/02783140.pdf