Coarse &Fine

Just to re iterate  on the first bulk sample pit  2-2 mtr  etc
Approximately 700 kg of mineralized conglomerate
was collected from a 2x2 meter exposure of bedrock at the bottom of a half meter deep trench.

This was the ANN....  We are most aware of this BBBBuuutttt don't forget There is a lot of PPL going on about no FIND GOLD but re-read the ANN

Results are presented in Table 1(Novo release below)
. The calculated head grade of
subsample #1 is 87.76 gpt Au, and subsample #2 is 46.14 gpt Au. The weighted average grade
of these two subsamples is 67.08 gpt Au


Rock fragments without identifiable coarse gold particles constitute the “ Sorted Tailings
.

Sample 1 was the visible  gold  down to a couple mm 86.76 gpt

Then sorted Concentrate was crushed to - 2 mm (P100) and coarse gold nuggets (“CoarseGold”) were recovered by hand during crushing.
A subsample of the crushed Sorted Concentrate was taken and assayed by screen fire assay.
Remaining crushed Sorted Concentrate  was then hand panned generating a gold concentrate (“Fine Gold Concentrate”), middling and tailing. The  Coarse Gold and
Fine Gold Concentrate were combined and acid washed


Sample 2 Was  of the unseen fine gold in the bedrock  not visible to the naked eye 46.14 gpt
The  Sorted Tailings  were crushed to
-2 mm (P100) and passed over a wet concentrating table
to produce a concentrate, middlings and tailings.Then acid leached   46.14 gpt.......

Continuosly seems to be missed  the unseen gold  result
Talked about  [sample 2 ]  of 46.14 gpt]
but not realised what it means   unseen fine fines